Another Stackable Drawer Boxes
par Asariuss
Fichiers imprimables (10)
-
stlSleeve_6cm.stl
120 Ko · 1 053 téléchargements
-
stl
Sleeve_8cm.stl
95 Ko · 1 036 téléchargements
-
stl
Sleeve_11cm.stl
110 Ko · 1 050 téléchargements
-
stl
Drawer-v1_8cm.stl
12 Ko · 1 023 téléchargements
-
stl
Drawer-v1_6cm.stl
13 Ko · 1 029 téléchargements
-
stl
Drawer-v1_11cm.stl
11 Ko · 1 026 téléchargements
-
stl
Drawer-v2_8cm.stl
5 Ko · 1 019 téléchargements
-
stl
Drawer-v2_6cm.stl
5 Ko · 1 021 téléchargements
-
stl
Drawer-v2_11cm.stl
5 Ko · 1 023 téléchargements
-
stl
Hang.stl
51 Ko · 1 022 téléchargements
Description
Parts are designed to print with 1mm nozzle with vase/spiral mode!
Simple organizing drawer boxes which can be hanged under shelf.
Drawers and sleeves are in 3 different lengths (6 cm, 8.8 cm and 11 cm) with 2 type of drawers with different handles. Side of sleeve square is 8 cm.
Joints are dovetail type with rectangular cavities to help hold sleeves in place after joining them together. Sleeves can be jointed with 50% offset increasing possibile combinations.
Sleeves have offset upper edge to better keep drawer inside.
Design already contains high tolerances but if you want to print this with different nozzle size than 1mm then i suggest print 2 sleeves but only 1 cm or 2 cm height to test joints and settings. If you want to print it with other nozzle size than 1mm then you must calculate your line width, perimeters count and bottom layers count by yourself.
perimeters count = 1 mm / line widthbottom layers count = 1.5 mm / layer height
Remember! No infill! No top layers!