Stackable Sieve
par les_kaye
Fichiers imprimables (5)
-
stlsieve.stl
140 Ko · 1 313 téléchargements
-
stl
sieve_no_support.stl
4 Ko · 989 téléchargements
-
stl
sieve_insert.stl
2 Ko · 1 290 téléchargements
-
stl
sieve_lid.stl
12 Ko · 952 téléchargements
-
stl
sieve_pot.stl
3 Ko · 986 téléchargements
Description
Sieve frame with insert to take a wire mesh approximately 150mm (6 inches) square.
The outside is 155mm square which is the largest that will fit on my print bed. The sieve has a coarse mesh to support your wire mesh or with no support if you are not giving it hard use.
I provide a pot to catch your powder.
There is a lid which can be useful when shaking the sieve.
Print the box, cut your sieve mesh to fit using the insert as a size guide then glue all in place with an impact adhesive.
This should be printed in a plastic with good layer adhesion. Use PLA or PETG as ABS will warp.