knife sharpener help
par Dennispelle
Fichiers imprimables (10)
-
stlMagnethalter.stl
77 Ko · 675 téléchargements
-
stlDrehgelenksimpel.stl
50 Ko · 1 460 téléchargements
-
stl
fussklemme.stl
143 Ko · 1 465 téléchargements
-
stl
Fuss_groß.stl
50 Ko · 1 468 téléchargements
-
stl
hochgelenk.stl
162 Ko · 1 465 téléchargements
-
stl
Steinhalter.stl
99 Ko · 1 457 téléchargements
-
stl
Rodjoint.stl
124 Ko · 1 459 téléchargements
-
stl
Fuss_groß.stl
50 Ko · 1 406 téléchargements
-
stl
Magnethalter.stl
77 Ko · 630 téléchargements
-
stlMesserklemmeV2.stl
178 Ko · 531 téléchargements
Description
There is an update: https://www.thingiverse.com/thing:4658514
Things you need
8mm rod: you need one long and two relative short. I have a 500m long one and two about 200mm.
8mm linear ball bearing
sharpening stone
m3 nuts and screws also four m4 screws. I would buy them at your local hardware store.
Who ever had a really sharp knife for chopping, cant life without it anymore. There are many things on Thingiverse, who did a great job with it, but there was always Something, wich Bothered me. The desings requierde a ton of filament and a printing time of several hours. Also there were two desings:
Some really small desings, with a kind of sled to remain the knife in the right angle. The stone stays still and the knife is beeing moved.
Some really big desingns, with rods and clamps with a fixed knife and a movable stone. This desings seemed superior to me, but I was concerned about the stone could crush my feet, when it comes off.
So I did a kind of remix the desings, with the stone fixed and the knife moving. I am sharpening my knifes for a couple of years now and I can tell, that I am a lot quicker now. And my knifes are sharp like a razor.
There are some issues with my desing too, but I will keep working on it, to make it easyer and cheaper to print.
Update 21.03.20: I made a new attachment for knifes. It uses a magnet 60x10x3 in mm. It is much better than the clamp. Stay tuned!