GPU Mining Mount

A simple mount to hold a GPU with a standard riser for mining. Should work for any 2 slot GPU.

The design works by flexing the vertical part back slightly to allow for it to then slide onto the part of the GPU you would normally screw into a PC case. This allows it to rigidly hold the GPU in place with no additional hardware.

You just need to find a suitable way of attaching this mount to your rig. I added some additional "sticky-out bits" off the centre and end section to give more options for attaching this mount to stuff - on my rig I just used duct tape around a few places onto the frame.

Printed in the used orientation, which means you need to do 2 bridges, but they are only short. If you don't print bridges well you may need to use a knife to clean out the slot for the card at the top.