Lightburn Camera Mount

par IcyPalm

Fichiers imprimables (4)

  • step

    Camera_bracket_v4.step

    62 Ko · 885 téléchargements

    Télécharger
  • stl

    camera_cradle.stl

    341 Ko · 928 téléchargements

    Télécharger
  • stl

    camera_main_holder.stl

    490 Ko · 924 téléchargements

    Télécharger
  • stl

    camera_cradle_top.stl

    417 Ko · 934 téléchargements

    Télécharger

Description

This is designed for the Lightburn camera, specifically for the fisheye-120 but any variant should fit. This is designed to fit on the inside onto the handle-bolts of the lid of the laser engraver/cutter. Specifically the KH-750 but presumably more chinese-red-laser engravers should fit.

Two M3 nuts and screws/bolts are needed to lock the swivel in place. The cover does not snap but has a very tight fit. I locked the camera in place with some tissue and locked the cover with two tie-wraps.

I based my design of these two other holders:

But needed to create my own that shifted the camera a bit more to the top of the lid since otherwise the laser-carriage would hit the camera.

I included a .STEP file and the Fusion360 design file if you wish to customize the design.

Tags

#camera #camera mount #kh-750 #lasercutter #laser engraver #lightburn #Lightburn Camera