Bicycle
par RoadHawkRide
Fichiers imprimables (12)
-
stltrapperas.STL
21 Ko · 8 064 téléchargements
-
stlframe.STL
142 Ko · 8 112 téléchargements
-
stlvoorvork.STL
217 Ko · 8 050 téléchargements
-
stlstuur_orientatie_tbv_printen.STL
882 Ko · 8 037 téléchargements
-
stlkrenk.STL
243 Ko · 7 995 téléchargements
-
stlstandaard.STL
301 Ko · 7 972 téléchargements
-
stlzadel_orientatie_tbv_printen.STL
463 Ko · 7 998 téléchargements
-
stltrapper.STL
109 Ko · 7 951 téléchargements
-
stltrapas.STL
607 Ko · 7 982 téléchargements
-
stlSchild.STL
211 Ko · 7 943 téléchargements
-
stlvoorwiel.STL
755 Ko · 8 048 téléchargements
-
stlachterwiel.STL
2.4 Mo · 7 958 téléchargements
Description
Bicycle printed on a UP! Mini.
It was intended as a trophy for being 12.5 years with the company.
I don't have a race bike nor intend to own one.
I took some information from the net about frames. From there I created a frame, the wheels and the rest. It came out that the front wheel should be smaller as the backwheel... so be it.
Known issues:
Play of the axles in their bearing could be reduced.
Play of the front fork in the frame is OK.
Play of the pedal-axle in the frame could be reduced.
To use an elastic band for a chain, carefully cut the right-rear leg from the frame, put the elastic band over the hubs, than glue it back in place.
The pedal-axles have a press fit into the kranks, holes in the kranks could be a bit larger.