Arcade Controller BIG case
door Ferjerez
Printbare bestanden (14)
-
stlpin.stl
164 Ko · 3 676 downloads
-
stljoystick_cover.stl
203 Ko · 3 692 downloads
-
stlright_panel.stl
875 Ko · 3 693 downloads
-
stlleft_panel.stl
876 Ko · 3 682 downloads
-
stlusb_cap.stl
436 Ko · 3 675 downloads
-
stlpin_x12.stl
1.9 Mo · 3 677 downloads
-
stl30mm_bottons_case.stl
2.9 Mo · 3 719 downloads
-
stlwires_and_24mm_buttons_cover.stl
13 Ko · 3 669 downloads
-
stlwires_and_24mm_buttons_case.stl
2.9 Mo · 3 700 downloads
-
stl30mm_buttons_plate.stl
1.2 Mo · 3 683 downloads
-
stl30mm_buttons_cover.stl
2.8 Mo · 3 711 downloads
-
stleuropean__joystick.stl
4.9 Mo · 3 732 downloads
-
stljoystick_case.stl
4.9 Mo · 3 718 downloads
-
stlpacman_joystick.stl
10.8 Mo · 3 873 downloads
Beschrijving
Hi!
Recently i bought an Arcade Controller Kit (http://www.ebay.es/itm/201344779838) and always wanted a big case so i designed this.
Not need much explanation. Just print an assemble.
Great for classics arcades on MAME emulator.
Only need some screws for fixing the joystick.
The modules are joined using some 'pins' and some glue. Lateral parts fits without glue. and covers for buttons and joystick just fits without glue or screws.
You have room for 6 buttons (30 mms) on top, one 30 mm button on every side (great for pinballs) and two 24 mms buttons in central module (Used for Coin and Start).
The central piece have room for the 'electronics' and i don't use any support, just put inside and conect all the wires.
Tip: Glue some EVA foam at bottom to get a good grip on table.
Tip:Use some 'cyanocrilate' based glue for PLA. Works really well.
Also has customized joystick!! I've included 2 customized joysticks for replacing the red ball: The european stick and a pac-man. Just screw on the metal bar.
Hope you enjoy it.
Have Fun!!