Pascal Engine
door ekowi
Printbare bestanden (12)
-
stlchamberwithsupport.stl
157 Ko · 940 downloads
-
stlgear1.stl
81 Ko · 945 downloads
-
stlchamber.stl
132 Ko · 946 downloads
-
stlgear2.stl
253 Ko · 956 downloads
-
stlcrank.stl
14 Ko · 948 downloads
-
stlrod.stl
14 Ko · 949 downloads
-
stlbottomplate.stl
37 Ko · 940 downloads
-
stlring.stl
81 Ko · 959 downloads
-
stltopplate.stl
77 Ko · 952 downloads
-
stlsupport2.stl
58 Ko · 950 downloads
-
stlgear3.stl
185 Ko · 953 downloads
-
stlsupport1.stl
44 Ko · 944 downloads
Beschrijving
This boat engine implements the principle of the pop-pop boat mechanically. Water is drawn into and expelled from a pressure chamber by means of a diaphragm moving up and down periodically. I mount the engine on a styrofoam "hull" and corrugated plastic "deck". The boat can move with speed about 15 cm/s. Notice that this engine has no underwater moving parts, the diaphragm is located above water level and only pushes and pulls trapped air inside the chamber.
The diaphragm here is made from silicone rubber cast on a 3d printed mold, but other materials could work, like plastic bag or umbrella fabric, maybe with silicone caulk for sealing. The power source is a 130 dc motor running from 2 AA batteries.
I printed the chamber with support material included in the stl file (vertical clearance 0.5mm) because automatic support blocks the outlet hole. There is also a version without support.
The second gear is printed 2x and have plain 3mm shaft hole. The third gear must be locked to the shaft by tapping and placing a nut against it. The shaft protrudes out to hold the crank, which is locked the same way. Anyway, there are 2.8mm and 3.2mm hole diameters, all the 2.8mm holes are for tapping and others plain.
Video of the boat: https://youtu.be/MhlXEtJgdNg