Grow Light Diffuser

I've moved into an apartment without sun-facing windows, so my plants needed a leg up. I really liked this inexpensive grow light setup from ACKE, but its sharp LED light was a bit too blinding for my taste. After looking up some info on diffusers to make sure I wasn't eliminating all the good it could do by putting something in front of the light, I built this enclosure to make it a bit more human friendly.

This project requires:

• 1x ACKE LED Panel Grow Light
• 2x all print files
• 16x M3x16mm Screws
• 16x M3 Washers
• 16x M3 Nuts
• 8x M3 Self-threading Torx screws (McMaster Part #96817A908)
• 4x Drywall screws and anchors
• 1x 12x12" (300x300mm) sheet of 1/8" (3mm) diffused plastic (I used Delrin, but Acrylic would also work)
• 18AWG solid-core wire for connecting panels

Here's the panel I used:
ACKE LED Panel Grow Light, Plant Light PCBA, Hydroponic Grow Light ,LED Grow Light Aluminum Board for Greenhouse,Grow Light Stand, Vegetative Growth of seedling, flowers, Herbs

https://www.amazon.com/dp/B076B1W99T/ref=sxr_rr_xsim_1?pf_rd_m=ATVPDKIKX0DER&pf_rd_p=4518303533042278392&pd_rd_wg=kRBwX&pf_rd_r=J7PDZSZQXMSNDHFRDSCV&pf_rd_s=desktop-rhs-carousels&pf_rd_t=301&pd_rd_i=B076B1W99T&pd_rd_w=Byu8m&pf_rd_i=grow+light&pd_rd_r=abaffb82-87b2-41b6-851a-5bcf1cc5c4a7&ie=UTF8&qid=1526245375&sr=1

I've also included the SW files so you can customize this design. This is a bit of a messy file as SW decided to shut down on me and I pulled the project back from a recovery folder. However, it should be really simple to adjust the bracket angle and wall fastener hole sizes to suit your own install situation.