Toothpaste Dispenser
door DanielMitchell
Printbare bestanden (5)
-
stlTOOTHBRUSH_HOLDER.STL
11 Ko · 29 732 downloads
-
stlSTAND.STL
8 Ko · 29 784 downloads
-
stlBASE.STL
17 Ko · 29 755 downloads
-
stlEXTRUDER_SHAFT.STL
20 Ko · 29 919 downloads
-
stlEXTRUDER.STL
37 Ko · 29 916 downloads
Beschrijving
This unique design/creation allows you to distribute toothpaste directly onto your toothbrush. It also acts as an additional toothbrush stand or holder.
• The toothpaste extruder can be locked in place to prevent tubes from rolling out.
• Additional toothbrush holders can be printed depending on the amount of users.
• The toothpaste extruder/roller can also be used separately as a portable version.
The design was printed and tested using Ultimaker Cura 3.6.0, with the following settings (PLA):
Base & Toothbrush Holders
layer height: 0.24
Infill: 35%
Supports: No
Stand
layer height: 0.20
Infill: 35%
Supports: Yes
Extruder & Extruder Shaft
layer height: 0.20
Infill: 35%
Supports: No
• The total print time can be expected at around 11 hours.
Don't forget to comment or like.
Thanks.