Minute Engine
door brlaw
Printbare bestanden (20)
-
stlClock_42_Spring_Spacer.STL
26 Ko · 1 051 downloads
-
stl
Clock-42-Gear-6-teeth.STL
527 Ko · 1 046 downloads
-
stl
Clock-42-Drive.STL
570 Ko · 1 043 downloads
-
stl
Clock-42-lever.STL
720 Ko · 1 044 downloads
-
stl
Clock_42_Plastic_Screw-2.STL
383 Ko · 1 044 downloads
-
stl
Clock-42-Frame-Back.STL
1013 Ko · 1 045 downloads
-
stl
Clock_42-Endstop.STL
183 Ko · 1 041 downloads
-
stl
Clock_42_Indicator.STL
339 Ko · 1 041 downloads
-
stl
Clock-42-Winder_Pawl.STL
327 Ko · 1 039 downloads
-
stl
Clock-42-Balance_Wheel.STL
948 Ko · 1 042 downloads
-
stl
Clock_42_Spacer_8.STL
105 Ko · 1 038 downloads
-
stl
Clock-42-Winder.STL
226 Ko · 1 046 downloads
-
stl
Clock-42-Spring_Case.STL
330 Ko · 1 042 downloads
-
stl
Clock_42_Retaining_Ring.STL
711 Ko · 1 040 downloads
-
stl
Clock-42-Frame-Front.STL
3.9 Mo · 1 044 downloads
-
stl
Clock-42-Spiral_spring.STL
2.1 Mo · 1 052 downloads
-
stl
Clock-42-escape_wheel_12_t.STL
2 Mo · 1 046 downloads
-
stl
Clock-42-Gear-1-64T-.STL
7.1 Mo · 1 045 downloads
-
stl
Clock-42-Gear-2-64T-.STL
7.1 Mo · 1 045 downloads
-
stl
Clock-42-Gear-3-64T-.STL
7.2 Mo · 1 047 downloads
Beschrijving
A design for a Minute engine
I have tried on several occasions to design a wooden clock with a Swiss Lever Escapement, but so far none has been really successful. The problem is that the lever requires a Balance wheel and Spring for it to work and I can not get a wooden spring to work successfully.
I developed Clock 29 as a 3D printed clock a couple of years ago and this used a plastic spring but in association with a gravity escapement, so as a development project, the design of the Minute engine is to look at some of the variables that would need to be resolved for a clock utilising a Swiss lever movement to function, see link below for full instructions.
https://brianlawswoodenclocks.blogspot.com/2020/09/a-design-for-minute-engine.html