Functioning Switchblade
door JohnyBoi
Printbare bestanden (14)
-
stlSwitchblade_edited_parts_comb_blade_V9.stl
129 Ko · 2 034 downloads
-
stlSwitchblade_edited_parts_spring_WORKING_1.stl
10 Ko · 2 042 downloads
-
stlCASETOP2.stl
58 Ko · 2 036 downloads
-
stlCASE2.stl
48 Ko · 2 035 downloads
-
stlBUTTON2.stl
36 Ko · 2 028 downloads
-
stlSwitchblade_edited_parts_original_blade.stl
77 Ko · 1 857 downloads
-
stlSwitchblade_edited_parts_slider_V5.stl
39 Ko · 1 833 downloads
-
stlV2_Use_Working_springs.stl
10 Ko · 477 downloads
-
stlV2_UseWorking_taller_slider.stl
32 Ko · 462 downloads
-
stlV2_Use_Case_top_bigger_cutout.stl
50 Ko · 460 downloads
-
stlV2_Use_Working_Original_Blade.stl
79 Ko · 447 downloads
-
stlV2_Use_CASE2.stl
48 Ko · 426 downloads
-
stlV2_Use_Final_Hellhound_Blade.stl
113 Ko · 444 downloads
-
stlButton_FIXED.stl
34 Ko · 48 downloads
Beschrijving
2023 (V2 (Use) FILES UPLOADED):
I looked back on this project and how Francis_MK3S remixed it to make it even better, I printed the files and realised it only worked after heavy modification so i made my own again, this time its near perfect. The button is tall enough so it cannot interfere with the slider and the blade, the case top slider gap was extended, the slider feet were cut down more, the blade rubber band latch was shortened so it would not be touched by the slider, Finally I added a "Hellhound blade" with the correctly sized latch to the rest of the files if you would rather use that. However for this to work you must print the blade & the springs without any elephants foot whatsoever. You could use a raft as this will mostly fix it.
Remixed from: https://www.thingiverse.com/thing:4394741
the original barely worked and you had to file loads of it down. With this remix you can print all the parts with a very high success rate and not have to do any post-processing apart from assembly.
(assembly video on original thing: https://www.thingiverse.com/thing:4394741 ) however i recommend 2 loombands or ones at that size
PETG works the best, but you can print all of the following parts in PLA successfully:
. Top case
. Bottom case
. Blade
. Button
It works better if you print these parts in PETG:
. Slider
. Springs
All parts explained:
. Case2: the case on the bottom that houses the blade, slider, springs and top case
. Casetop2: top half of the case, goes in-between the button and slider
. Slider: holds a rubber band and moves the springs apart for the blade
. Comb blade: the blade but with a comb so its practical
. Original Blade: pointy blade with sharp edges
. Springs: both go inside the triangular gaps in the bottom case
. Button (FIXED): goes on the slider above the top case
Parts that may need changes in the slicer:
. Button - you may need to scale this to ~102% if it doesn't fit well