Float Level Switch

door Trigger52

Printbare bestanden (7)

  • stl

    Main_Body.stl

    218 Ko · 165 downloads

    Downloaden
  • stl

    RodFlag.stl

    1 Ko · 163 downloads

    Downloaden
  • stl

    LedLens.stl

    21 Ko · 165 downloads

    Downloaden
  • stl

    Cover.stl

    219 Ko · 161 downloads

    Downloaden
  • stl

    Mesh.stl

    206 Ko · 164 downloads

    Downloaden
  • stl

    Float.stl

    462 Ko · 172 downloads

    Downloaden
  • stl

    Conduit.stl

    407 Ko · 167 downloads

    Downloaden

Beschrijving

A float level sensor using a RAMPS optical endstop and a piece of 20mm electrical conduit.

  1. The main body needs supports.
  2. The float should be printed in vase/spiral mode with a extrusion width of 0.8mm
  3. The connecting rod/flag 100% infill
  4. Use a piece of clear filament as a light pipe for the LED indication
  5. Use some soldering wire to add weight to the float, just wrap some around the rod above the float.

I seal up the float by submerging the float and rod into acetone for a few seconds and blow dry. repeat 2 or 3 times.

Tags

#float #level #swich #water #water pump