DIN CASE FOR SONOFF BASIC R2

par NB56

Fichiers imprimables (5)

  • stl

    DIN_sonoff_basic_-_box.stl

    1 Mo · 1 495 téléchargements

    Télécharger
  • stl

    DIN_sonoff_basic_-_cover.stl

    137 Ko · 1 463 téléchargements

    Télécharger
  • stl

    DIN_sonoff_basic_-_spring_clip.stl

    77 Ko · 1 471 téléchargements

    Télécharger
  • stl

    DIN_sonoff_basic_-_pusher.stl

    348 Ko · 1 460 téléchargements

    Télécharger
  • stl

    DIN_sonoff_basic_-_cable_clamp.stl

    136 Ko · 1 445 téléchargements

    Télécharger

Description

DIN CASE FOR SONOFF BASIC R2
Width = 1.5 module (1 circuit breaker = 1 module)

Content to print:

  • 1 box
  • 1 cover
  • 1 spring clip
  • 1 pusher
  • 2 cable clamps

Use :

  • The push button on the front panel activates the card button (on / off).
  • A hole in the front allows you to see the LED

Assembly, integration into the board:

  • Place the spring clip in its housing (respect the direction of the profile in relation to the din rail)
  • Cut the front tab print support at the bottom of the case (see photo)
  • Insert the pusher into its hole and turn it until it slides without friction
  • Clip the Sonoff card under the rear tabs, then the front tab
  • Wire the terminal blocks, tighten the cable clamps
  • Screw on the cover (3 countersunk head screws M2.5-12)
  • Place the box on the din rail and block the spring clip

IF YOU LIKE THIS OBJECT, PLEASE LEAVE A LIKE, A COMMENT OR A MAKE.

Tags

#basic #case #diy #electrical #enclosure #sonoff #sonoff basic