DIN CASE FOR SONOFF BASIC R2
di NB56
File stampabili (5)
-
stlDIN_sonoff_basic_-_box.stl
1 Mo · 1 495 download
-
stl
DIN_sonoff_basic_-_cover.stl
137 Ko · 1 463 download
-
stl
DIN_sonoff_basic_-_spring_clip.stl
77 Ko · 1 471 download
-
stl
DIN_sonoff_basic_-_pusher.stl
348 Ko · 1 460 download
-
stl
DIN_sonoff_basic_-_cable_clamp.stl
136 Ko · 1 445 download
Descrizione
DIN CASE FOR SONOFF BASIC R2
Width = 1.5 module (1 circuit breaker = 1 module)
Content to print:
- 1 box
- 1 cover
- 1 spring clip
- 1 pusher
- 2 cable clamps
Use :
- The push button on the front panel activates the card button (on / off).
- A hole in the front allows you to see the LED
Assembly, integration into the board:
- Place the spring clip in its housing (respect the direction of the profile in relation to the din rail)
- Cut the front tab print support at the bottom of the case (see photo)
- Insert the pusher into its hole and turn it until it slides without friction
- Clip the Sonoff card under the rear tabs, then the front tab
- Wire the terminal blocks, tighten the cable clamps
- Screw on the cover (3 countersunk head screws M2.5-12)
- Place the box on the din rail and block the spring clip
IF YOU LIKE THIS OBJECT, PLEASE LEAVE A LIKE, A COMMENT OR A MAKE.