HyperCube 3D Printer Accessory Pack

von Tech2C

Druckbare Dateien (8)

  • stl

    Dremel_Clamp_25mm.stl

    72 Ko · 21 015 Downloads

    Herunterladen
  • stl

    Dremel_Mount_25mm.stl

    132 Ko · 20 979 Downloads

    Herunterladen
  • stl

    RepRapDiscount_Smart_Controller_mount.stl

    112 Ko · 33 521 Downloads

    Herunterladen
  • stl

    Extruder_cable_support.stl

    217 Ko · 33 056 Downloads

    Herunterladen
  • stl

    Spool_Holder.stl

    605 Ko · 33 848 Downloads

    Herunterladen
  • stl

    RAMPS_mount.stl

    243 Ko · 33 603 Downloads

    Herunterladen
  • stl

    Power_Mount.stl

    451 Ko · 33 568 Downloads

    Herunterladen
  • stl

    SKR13_mount.stl

    198 Ko · 15 059 Downloads

    Herunterladen

Beschreibung

Optional extras for the HyperCube 3D Printer.
https://youtu.be/o3PU-MJzh98

RepRap Discount Smart Display Mount (Print 2 of them)
Mount anywhere on the frame where the LCD + SD cables reach.
Requires:

  • 4 x M5x10mm button head screws
  • 4 x M5 T-slot nuts
  • 4 x M3x10mm screws
  • 4 x M3 hex nuts

X-Carriage Cable Mount
Install on the top rear left of the frame. There is a channel for a cable tie to affix a cable loom of up to 16mm in diameter.
Requires:

  • 2 x M5x10mm button head screws
  • 2 x M5 T-slot nuts
  • 1 x 100mm cable tie

Stepped Spool Holder (Print 2 of them)
Each spool holder accepts 2 x 608 bearings. This ensures the spool holder is always vertical with the spool.
Requires:

  • 4 x 608 radial bearings

RAMPS Mount
A bracket to support the Arduino Mega 2560 and RAMPS 1.4 board to the bottom rear left of the frame. Cable management on the rear of the bracket allows excess cable length to be wrapped around neatly.
Requires:

  • 3 x M5x10mm button head screws
  • 3 x M5 T-slot nuts
  • 3 x M3x25mm screws
  • 3 x M3 hex nuts

BIGTREETECH SKR v1.3 Mount
A bracket to support the SKR v1.3 board to the bottom rear left of the frame. Cable management on the rear of the bracket allows excess cable length to be wrapped around neatly.
Requires:

  • 3 x M5x10mm button head screws
  • 3 x M5 T-slot nuts
  • 3 x M3x10mm screws
  • 3 x M3 hex nuts

Power Supply Mount
A bracket to support the 12v 30A power supply to the bottom rear right of the frame.
Requires:

  • 3 x M5x10mm button head screws
  • 3 x M5 T-slot nuts
  • 3 x M4x10mm screws (thread of the power supply chassis)
  • 2 x M3x10mm countersunk screws (for power socket)
  • 2 x M3 hex nuts (for power socket)
  • 1 x Power Supply Socket - Fused

Tags

#hypercube