LACK table printer hinge/ latch
von Reciprocation_Props
Druckbare Dateien (3)
-
stlhinge_part_2_v2.STL
600 Ko · 1 246 Downloads
-
stlhinge_part_1_v2.STL
810 Ko · 1 211 Downloads
-
stlhinge_pin_v1.STL
37.5 Mo · 1 244 Downloads
Beschreibung
This is a latch/ hinge for converting a Ikea Lack table into a 3d printer enclosure, just print 3-4 of each part and install 2 as hinges and the other 1 or 2 as latches. There is a cut out on the back of one side meant for foamcore/ acrylic/ polybarbonate to be attached. The holes in the hinge plates are .125in across and the cut out is also .125in deep. It took about 5.5 hours to print all of the parts at .2mm.