DecoTime angular timer
von coolate
Druckbare Dateien (5)
-
stlDecoTimeTOP.stl
2.1 Mo · 592 Downloads
-
stldecoTimeBottom.stl
2.2 Mo · 584 Downloads
-
stlDecoTimeSolenoidClip.stl
108 Ko · 582 Downloads
-
stldecoTimeKickstand.stl
39 Ko · 583 Downloads
-
stldecoTimeBatteryDoor.stl
12 Ko · 587 Downloads
Beschreibung
DecoTime is my Art Deco styled timer. It is powered by an Arduino driving two x27 168 or switec X25 stepper motors moving the needles. It also uses a MCP23S17 to drive the LEDs and take input from the two rotary encoders. A solenoid rings the bell when finished and the top LED flashes. It can be run off batteries(alkaline or NiMh), or usb. It also has an expansion port to use I2C with power. You can find the knobs, battery pack, and needles in my other uploads on thingiverse.
You can read all about it in great detail on my website, including schematics and directions.
http://coolate.com/blog/coolate-pages/deco-time-angular-timer/
I printed the parts on an ultimaker, seeMeCNC and an old makerbot. The two main parts require supports, and should be printed inside down toward the plate. I used PLA, and coated some parts in XTC to make them shine.
ALL the design work was done in tinkercad, and are public if you want to fiddle with it.
Needles/hands:
https://www.thingiverse.com/thing:2308109