Backgammon Board
von diabeetusman
Druckbare Dateien (6)
-
stlboard_half_mirrored.stl
25 Ko · 659 Downloads
-
stl
board_half.stl
25 Ko · 659 Downloads
-
stl
small_bowtie.stl
4 Ko · 622 Downloads
-
stl
large_bowtie.stl
3 Ko · 615 Downloads
-
stl
stone.stl
89 Ko · 638 Downloads
-
stl
triangle.stl
484 o · 630 Downloads
Beschreibung
- 30x pieces, 15 of each if printing in different colors
- 2x large bowties
- 2x small bowties
- 2x board halves
- 2x board halves (mirrored)
- 24x triangles, 12 of each if printing in different colors
- These magnets (optional)
- These dice
I used magnetic filament for the triangles and painted them with spraypaint afterwards.
Use whatever colors you want and whatever plastic.
A little support material is needed for where the bowties fit in, but not a whole lot.
Assembly InstructionsThe magnets should fit in the pieces without any glue. Make sure they're all facing in the same direction so the pieces can stack.
The triangles required a little sanding to get to fit, but not much. No gluing necessary here either.
The bowties needed some expoxy, but that's optional I suppose. I left one half of the board unglued from the other so that it can be removed and folded over and secured with a rubber band for storage