Giant Eagle
von m_nan
Druckbare Dateien (11)
-
stlGiant_Eagle_diving_based.stl
8 Mo · 4 430 Downloads
-
stlGiant_Eagle_diving.stl
3.7 Mo · 3 940 Downloads
-
stlGiant_eagle_diving_pinned_WingL.stl
537 Ko · 3 506 Downloads
-
stlGiant_eagle_diving_pinned_WingR.stl
374 Ko · 3 484 Downloads
-
stlGiant_eagle_diving_pinned_body.stl
2.3 Mo · 3 465 Downloads
-
stlGiant_eagle_diving_pinned_head.stl
1000 Ko · 3 516 Downloads
-
stlGiant_eagle_diving_pinned_PIN.stl
46 Ko · 3 396 Downloads
-
stlGiant_eagle_diving_pinned_talons_precise.stl
1023 Ko · 3 367 Downloads
-
stlGiant_eagle_diving_pinned_talons_simple.stl
1.1 Mo · 3 311 Downloads
-
stlGiant_eagle_diving_pinned_body_no_talons.stl
1.6 Mo · 3 343 Downloads
-
stlvulture_head.stl
961 Ko · 3 289 Downloads
Beschreibung
UPDATE
Turns out that the details on the talons are pretty tricky to print. I managed to, with minimal loss during cleanup (just a single claw of one talon) but I realize that such small details are far from necessary at TTRPG scale.
So I simplified the talons, and in any case separated them from the body so if the print fails you can just try again without the rest of the body.
Also added another head for the ones who prefer a vulture vibe.
From
Condor des Andes male by Alienor.org - Conseil des musées
Common wildshape for druids.
Remix of
28mm Giant Eagles by PhysUdo for the wings and tail
and
Golden Eagle Claw by steinalder for the talons
The body and head are from a model I found lying within Win10, there's a whole bunch you can export to glb and then to stl via blender. Who knew!
There's an error one one side of the body where the pin should be and two holes kind-of overlap. I boolean'ed it and saved before realizing the pin was in the wrong spot. It shouldn't be a problem, tho, that part will not be visible once the model is assembled.