Game Controller Hanger

Description

This is a hanger to hold a game controller under a table.

• The hanger features a two leg claw design, to hold on to the game controller.
• The wide radius and the angle of the hanger enable an easy setting and removing of the controller, even when not looking (which would be difficult, when mounted under the table).
• The sides are rounded, so the controller self centers on the hanger when placed or when slightly nudged or shaken.
• The oval hole on the back enables the controller to be plugged in and charged.

Compatibility

Any controller with a flat section of at least 65 mm between the two handles should be compatible with this hanger.

The following Controller had been tested and are compatible with this hanger:

• Xbox Series X Controller
• Xbox One Controller
• Nintendo Switch Pro Controller

If you test this hanger with other controllers, please give feedback in the comments to let other users know if this controller is compatible.

Assembly

The hanger is printed in one piece.
You can use Ø3 mm - 3.5 mm screws (recommended) or double-sided tape to secure the hanger to your table.
(The screw holes are Ø4 mm. So you may be able to use Ø4 mm screws as well.)