Raspberry Pi Zero Camera Case

by ReallyBigTeeth

Printable files (1)

  • stl

    Pi_Zero_W_Camera_Case.stl

    392 Ko · 3 566 downloads

    Download

Description

If you like what you see here, consider leaving a tip.

A Raspberry Pi Zero camera case with with snap on back plate. This was designed as part of an OctoPrint project for the Felix 3D printer.

Instructions:

  1. With the case and back plate printed insert the Pi camera as shown in the picture below.

  2. Fully seat the camera making sure the camera lens passes through its hole and the board is being retained by all four clips. You may need to push the clips to the side in order to slide the camera board past them.

  3. Next, attach the 38mm camera ribbon cable.

  4. Place the Raspberry Pi in the case, securing it with the snap-in back plate.

Tags

#octopi #octopi case #Octoprint #OctoPrint case #pi camera #Pi camera case #Pi Case #pi z camera case #pi z case #pi z w case #Pi Zero #pi zero camera case #Pi Zero Case #pi zero w #pi zero w camera case #Pi Zero W Case #pi zw case #PiZ #Raspberry Pi #raspberry pi camera #raspberry pi case #Raspberry Pi Z #raspberry pi z case #raspberry pi Z W #Raspberry Pi Zero #Raspberry Pi Zero W #raspberry pi zw