Mono X Replacment Knobs
by Cinpro
Printable files (6)
-
stlMonoX_Plate_Knob_Size_Test_Blank.stl
89 Ko · 672 downloads
-
stlMonoX_Knob_3.stl
1.4 Mo · 701 downloads
-
stlMonoX_Knob_1.stl
1.4 Mo · 688 downloads
-
stlMonoX_Knob_2.stl
2.1 Mo · 678 downloads
-
stlMonoX_Knob_3_supported.stl
4.3 Mo · 671 downloads
-
stlMonoX_Knob_JUMBO.stl
2.2 Mo · 583 downloads
Description
simple replacement knobs for the MonoX build plate
you'll need an 8mm bolt X 25-30mm long and an M8 nut
There is a test piece included so you can account for any shrinkage and save resin. you will likely need to scale the part up a little. I made several copies in different scales all at once to find my size. One at 100% and then a couple more in larger scales (101% 1003% etc) be sure to wash and cure before deciding on which one to use.
EDIT: I added a Jumbo sized knob for someone who may have difficulties gripping a smaller one. I actually drew this up and printed it, but it came out a little larger than I expected and did not have any intentions of uploading it until I read about some people who had a disability or injury. I thought this may make their life easier so I added it.