Snap-On Cable Winder for Cable Management | ZERO Community Accessory

A simple snap-on cable winder designed for clean desk setups and portable cable management in backpacks and everyday carry setups.

This accessory was born from two separate community suggestions:

• One ZERO disciple suggested a cable winder.
• Another realized that the camera hole in the battery could be used to carry cables.

We combined both ideas into a lightweight modular accessory that attaches directly to ZERO or can be used as a standalone.

You have 2 versions:

• Small : Adapted for small cables.
• Big : Deeper body for longer cables.
• Feel free to resize to adapt to your needs.e.

FEATURES

• snap-on mounting system
• lightweight and low material usage
• fast print time
• clean cable routing
• No supports required (recommended orientation)
• remix-friendly geometry
• modular attachment system

USE CASES

• desk cable management
• workspace organization
• minimal setups
• maker desks
• portable setups

PRINT SETTINGS

• Layer height: 0.2 mm
• Material: PLA, ABS or PETG
• Infill: 15–20%
• Supports: not required

This project is part of the evolving ZERO ecosystem:

ZERO is a modular battery system shaped alongside its community.

We are releasing this design open source for makers to print, modify, and remix freely.

If you improve or remix it, share it with the community so the ecosystem evolves.

→ Join the community .

→ Follow on Kickstarter.

Keywords:
cable winder, cable organizer, desk cable management, backpack cable organizer, modular accessory, snap-fit design, workspace setup, clean desk, 3D printed cable holder, cable routing, travel organizer, open source hardware, remixable design, ZERO ecosystem