Hypercube Evolution Z Axis (Three Stepper)
por StvPtrsn
Archivos imprimibles (12)
-
stlZ_ZyltechABL-Nut_Bracket_Right_Rear.stl
278 Ko · 2 506 descargas
-
stlZ_ZyltechABL-Nut_Bracket_Right_Front.stl
278 Ko · 2 496 descargas
-
stlZ_LM12UU_Bearing_Cap.stl
124 Ko · 2 494 descargas
-
stlZ_Stepper_Mount_Right_Front.stl
164 Ko · 2 134 descargas
-
stlZ_Stepper_Mount_Right_Rear.stl
164 Ko · 2 130 descargas
-
stlZ_ZyltechABL-Nut_Bracket_Left.stl
200 Ko · 2 491 descargas
-
stlZ_Stepper_Mount_Left.stl
123 Ko · 2 487 descargas
-
stlZ_Rod_Bracket.stl
128 Ko · 2 493 descargas
-
stlZ_AmazonABL-Nut_Bracket_Right_Rear.stl
209 Ko · 2 344 descargas
-
stlZ_AmazonABL-Nut_Bracket_Right_Front.stl
209 Ko · 2 344 descargas
-
stlZ_AmazonABL-Nut_Bracket_Left.stl
131 Ko · 2 480 descargas
-
stlAmazon_ABL_Nut_Cap.stl
406 Ko · 2 243 descargas
Descripción
These are the Z axis parts I modeled to use three individually controlled steppers. Since my frame build started with the standard configuration spreadsheet one major goal for this was to be able to use those standard 3030 (main frame) and 2020 (heated bed frame) extrusion lengths. Therefore all basic dimensions are based on Scott's original models which should allow for fairly easy conversion if your build is based on the configurator as well.
My other Hypercube Evolution remixes can be found by going to this collection:
https://www.thingiverse.com/StvPtrsn/collections/my-hypercube-evolution-remixes
I am using a Duet2 WiFi with the Duex5 addon board to allow for independent control of three Z steppers for tilt correction. See this Duet3D documentation page for more information:
https://duet3d.dozuki.com/Wiki/Bed_levelling_using_multiple_independent_Z_motors
Feel free to leave any comments or suggestions. If you use any of this please post a make and/or remix. Step files provided for all files.
Although I've built the printer to the point it will home, tilt adjust, mesh bed compensate and the X carriage can be moved in the full range of motion, I am going to leave the work-in-progress tag on this until I actually get some prints off of it. Please check the change log below for any updates.