Generic push puppet
por broodrooster
Archivos imprimibles (11)
-
stlpushbutton.stl
443 Ko · 457 descargas
-
stl
base_24mm.stl
188 Ko · 461 descargas
-
stl
foot.stl
502 Ko · 469 descargas
-
stl
leg.stl
785 Ko · 458 descargas
-
stl
torso.stl
1.5 Mo · 461 descargas
-
stl
arm.stl
1.1 Mo · 463 descargas
-
stl
head.stl
1.5 Mo · 464 descargas
-
stl
button.stl
811 Ko · 469 descargas
-
stl
blank_plaque.stl
33 Ko · 460 descargas
-
stl
test_plaque.stl
936 Ko · 464 descargas
-
stl
base_29mm.stl
188 Ko · 456 descargas
Descripción
This is a generic humanoid push puppet, for use with a metal spring that measures roughly 10.5mm OD and 30mm long and produces about 5 lbs of force when fully compressed. There are some notes about using this model with other springs, see below.
The head and arms are mounted on flat-bottomed "buttons" that should make it somewhat easier to string and tension the puppet. You can also swap out the head and arm pieces at will.
There is also a space for a plaque which you can customize with your own message.
The zipfile contains all of the contents of this Thing
You will need the following:
1 spring (ideally 10.5mm OD, 30mm long, 5 lbs)
1 spool of polyester sewing thread, or fishing line
and print the following parts:
1 base (use "base_24mm.stl" unless you're experimenting with a stronger spring)
1 pushbutton
2 feet (make sure one is mirrored, unless you want your puppet to have 2 left feet)
2 leg sections
1 torso
2 arms
1 head
3 "button" anchors
1 plaque to decorate the front of the base (optional)