Push Block
por theMachinista
Archivos imprimibles (17)
-
stlMain_Body.stl
120 Ko · 1 521 descargas
-
stl
Handle_Heatsert.stl
992 Ko · 1 488 descargas
-
stlHandle_2.stl
190 Ko · 1 325 descargas
-
stl
12mm_Side.stl
57 Ko · 1 455 descargas
-
stl
6mm_Side.stl
57 Ko · 1 453 descargas
-
stl
Middle_Leg.stl
21 Ko · 1 450 descargas
-
stl
Tail.stl
1 Ko · 1 440 descargas
-
stl
Leg_Extension.stl
69 Ko · 1 453 descargas
-
stl
Stabilizing_Leg.stl
462 Ko · 1 457 descargas
-
stlTall_Knob.stl
887 Ko · 1 305 descargas
-
stlShort_Knob.stl
878 Ko · 1 303 descargas
-
stl
Knob_Screw_Plug.stl
30 Ko · 1 441 descargas
-
stl
Knob_Nut_Plug.stl
46 Ko · 1 437 descargas
-
stl
Tee_Nut.stl
29 Ko · 1 445 descargas
-
stlStabilizing_Plate_Left.stl
45 Ko · 770 descargas
-
stlStabilizing_Plate_Right.stl
45 Ko · 769 descargas
-
stlStabilizing_Plate.stl
45 Ko · 775 descargas
Descripción
This is a remix of Trobinou's saw/router table push block with the holes in the main body, Side Plates, and handles resized to accept heat set thread inserts.
You'll need 12 m4 inserts to press into the main body and side plates, and two m5 inserts to press into the bottom of the handle.
Other changes I've made are extending the tee track through the side plates to make it easier to install extra tee plates for other accessories. I've also added slots in the edges of the stabilization plate. Made a reversible handle and middle leg with tails on either sid, and created a side plate extension.
The basic dimensions and screw holes are located to make everything interchangeable with Trobinou's original design.
I've also included my f3d file for anyone else who wishes to change or add to the functionality of this handy tool.
05/19/21 Edited design with three different stabilizing plates. One plain, and one each with the hook on the left and right for pushing against either side of the saw fence.