Breadboard Case

A simple case to hold the GL-12-F K&H Breadboard commonly used in many university courses, like UNSW and for other projects.
The case has a small compartment on the top section with slide lid lid draw to keep individual components and wires organized. This allows for components in use to be kept in the open lid of the top section, or assembled circuits to be transported with adequate clearance once box is closed.

Breadboard Dimensions:
Fits the GL-12-F K&H Breadboard-840 Tie Points

No support material is used, so slide channel, slide lid and top/bottom edge lips need a little bit of filing to ensure a smooth firm fit.

A piece of wire was used as a hinge. The hinge holes are 3mm diameter, so an M3 bolt should also work well.
Easily adapted and improved to your specific needs.