Flipper Zero - Wi-Fi Dev Board Case (Basic)
por CodyTolene
Archivos imprimibles (8)
-
3mfFlipper_Zero_WiFi_Dev_Board_Case_Bottom.3mf
98 Ko · 755 descargas
-
stl
Flipper_Zero_WiFi_Dev_Board_Case_Bottom.stl
277 Ko · 935 descargas
-
stl
Flipper_Zero_WiFi_Dev_Board_Case_Top.stl
174 Ko · 903 descargas
-
3mf
Flipper_Zero_WiFi_Dev_Board_Case_Top.3mf
59 Ko · 745 descargas
-
stl
Flipper_Zero_WiFi_Dev_Board_Case_Top_and_Bottom.stl
450 Ko · 954 descargas
-
3mf
Flipper_Zero_WiFi_Dev_Board_Case_Top_and_Bottom.3mf
134 Ko · 770 descargas
-
3mf
Flipper_Zero_WiFi_Dev_Board_Case_Top_Closed.3mf
59 Ko · 719 descargas
-
stlFlipper_Zero_WiFi_Dev_Board_Case_Top_Closed.stl
185 Ko · 798 descargas
Descripción
This print is specifically designed for the basic WiFi board straight out of the box, omitting features such as the antenna and SD card slot.
This creation is a remix of magdong's Wi-Fi Dev Board Case (https://www.thingiverse.com/thing:5564906).
For secure assembly, utilize 4 x M3x12mm screws accompanied by 4 x M3 nuts.
This design also has a pin protector boot cover that can be found in the following locations:
- https://www.thingiverse.com/thing:6104552
- https://www.printables.com/model/606861
https://github.com/CodyTolene/3D-Printing/tree/main/Flipper%20Zero%20-%20WiFi%20Dev%20Board%20Case%20Boot%20Cover
My print settings:- Hatchbox PLA
- 0.2mm layer height
- 0.4mm nozzle (line width)
- Enable retraction
- Wall count 3 (+ print thin walls enabled)
- Top/bottom layers: 4
- Infill density: 20%
- Infill pattern: Cubic
- Print temp 200 C
- Bed temp 60 C
- No supports needed
See more designs on my GitHub here: https://github.com/CodyTolene/3D-Printing