AntweightShellSpinner
di AdamDC
File stampabili (7)
-
stlShellSpinnerGuard.stl
25 Ko · 994 download
-
stlShellPressureDrive.stl
76 Ko · 985 download
-
stlN20MotorMounts.stl
46 Ko · 988 download
-
stlLegoWheelHubSmall-3mm.stl
37 Ko · 997 download
-
stlShellSpinnerShell.stl
99 Ko · 994 download
-
stlShellSpinnerBase.stl
129 Ko · 995 download
-
stlShellSpinnerTopHub.stl
157 Ko · 984 download
Descrizione
These are the current files for the 1 pound plastic fighting machine called "Plastique". I will post full parts lists and additional instructions, but for now I thought the parts would be of interest.
The only video I could find of this robot winning (it doesn't win much, it usually turtles) https://youtu.be/5kx_2t19lqg
Drive motors: N20 50:1 (or similar) x2 https://hobbyking.com/en_us/brushed-motor-15mm-6v-20000kv-w-50-1-ratio-gearbox.html?wrh_pdp=2
Tires: Lego small, wide tires. Photo included
Weapon motor: Hobby King "Donkey" brushless motor. Example: https://hobbyking.com/en_us/hobbyking-donkey-st3511-810kv-brushless-power-system-combo.html
I've used an assortment of brushed motor ESC for drive and brushless ESC's for the weapon. Any standard small combat robot ESC's will do, the smaller the better.
You'll need an assortment of 4-40 nuts and bolts.
At least 15cm of 6mm steel (or something) rod.
6mm ID shaft collars x2 (one for the top and one for the bottom)
Small Reciever, bot requires 3 channels (2x for drive 1x for weapon)
One light duty spring, approx 1" diameter.
One 1" foam (or other) tire for the weapon drive.
The shell does draw a lot of current spinning up, so a larger battery is better. No less than 250mah for 3 minute battle.