dynamixel servo case
di cruice
1 / 11
File stampabili (3)
Descrizione
This is my very first 3d model, so please show mercy is its only 99.5% accurate, but it works well ;)
So here is at case that makes it posible to use standard servo's as futaba s3003 / hitec hs-311 or similar.
Thing log:
-12-03-2019. first model upload (half flange).
-13-03-2019. full flange model added.
Fitting instructions:
-unscrew servo bottom lid.
-fold wires down, and cut the small wire guide of the servo (see pic).
-print and fit servo lid with fake shaft. (tribute to obijuan / https://www.thingiverse.com/thing:30707/files)
-snap servo in dynamixel case, and screw it in.
Note: servo wheel goes on the outside, if used on poppy (https://www.thingiverse.com/thing:2280067) ( see picture).
happy robotics :)