Hypercube Evolution Tool Changer V1.4
di Adam8803
File stampabili (10)
-
stlX_Carriage_Attachment_Positioning_Pin.stl
2 Ko · 6 351 download
-
stlX_Carriage_Attachment.stl
616 Ko · 6 329 download
-
stlParking_Tool_Holder.stl
20 Ko · 6 326 download
-
stlFan_Duct_Stationary_Part.stl
30 Ko · 6 306 download
-
stlBL_Touch_Consol.stl
41 Ko · 6 296 download
-
stlV6_CLAMP.stl
114 Ko · 5 585 download
-
stlVolcano_holder.stl
220 Ko · 5 598 download
-
stlV6_HOLDER.stl
220 Ko · 5 573 download
-
stlCR_10_Holder.stl
305 Ko · 5 579 download
-
stlVOLCANO_CLAMP.stl
179 Ko · 5 563 download
Descrizione
// I will post the Step files of this design //
Hi Everyone!
Here is a tool changer system for Hypercube evolution.
You can use the stock X carriage.
I print them on an Eden500 polyjet machine. So I can't advise you how to print it on FDM.
You need to put a 3mm spacer between the Bl Touch and the holder
On the assembly picture You cannot see the X carriage positioning pins. They are (4 pieces) between the stock X carriage, and the base attachment.
For the "locking mechanism" You will need 6mm diameter flat magnets, 3 for the base, and 3 for each tool holder.
Optionally You can put 1-1 magnets to the parking tool holder, and the tool clamp, to ensure the parking tool to stay where it should.
For the Optical Endstop, you need to drill one or two holes.
The parking tool holder fits for 3030 aluminum extrusion, and you need to file the top, bottom and one side of the holding pin, it's designed exactly the same shape as the hole in the tool head, so its needed to remove some material to make it attach and detach freely
2019.04.14
Modified tool clamps (it was hard to insert the hotend, now its easier)
- Added VOLCANO hotend holder
- Added CR-10 hotend holder (it will be redesigned, its just a quick design)
- Added different type of tool clamps (V6, Volcano)