HyperCube Evolution Refurbishment 2022
di BoothyBoothy
File stampabili (11)
-
stepZ_Motor_Mount_20mm_Extention_V1_1.step
235 Ko · 750 download
-
step
Z_Axis_Liner_Rail_Bracket_with_aperture.step
184 Ko · 739 download
-
step
WM_Clip_System_V1_1.step
1001 Ko · 736 download
-
step
3010_Based_Hot_End_with_Dragon__Orbiter_V1_5.step
7.4 Mo · 796 download
-
step
Slot_Board_V1_1.step
208 Ko · 709 download
-
step
Electronics_Enclosure_V1_1.step
3.9 Mo · 745 download
-
step
Manta_MK2_Adapter__Parts.step
4.7 Mo · 769 download
-
step
PSU_Holder__Parts_V1_1.step
988 Ko · 722 download
-
step
WM_Clamps__Clip.step
1.1 Mo · 731 download
-
step
LH_XY_Joiner__End_Stops_Flags.step
967 Ko · 792 download
-
stl
Enclosure_Rear_Panel_V1_1_x1.stl
1.2 Mo · 791 download
Descrizione
After 2 long hard years of service I decided my HEVO needed some TLC.
Within the refurbishment I Klipperised the HEVO so I also had to revise my Electronics Enclosure design. The wire management of the HEVO is so much easier without a display.
The Parts I have revised are:
1.Easy Access Electronics Enclosure
2.PSU Stand Holder with Individual USB feed if required.
3.Wire Management Clip System to tidy up cables along the Extrusion slots.
4.Modified Z Axis Linear Rail Mount to allow cable pass through for End Stop Feeds.
5.New Flexible Hot End Mount with lots of fixing points rather than 3mm studs.
6.Manta MK2 & Boothy Mini Hot End assemblies (Primarily for the Dragon & Orbiter V1.5).
7.Revised Z motor Mount to increase Z height if required.
Video Here: https://www.youtube.com/watch?v=irDnK233_Uc
I have also revised the original mounting plate to include lots of fixing points for future proofing. I have included optional Hot Ends for Both My Manta MK2 design and a even more compact option using 3010 turbo part cooling fans. Please note the Rear Mount in the Mini Hot End step file as a mounting centre reduced by 0.4 mm because I had some slight binding with the X gantry. The mount in the Manta Mkl2 step is standard. I thought I would upload both for flexibility.
I hope that some of the community may find these shared files useful. Due to the complex number of parts and my limited time I have uploaded only the step files for each upgrade so this thing should be considered\assessed on that basis. I am more than happy to respond to comments regards specific parts or details but I do not intend to spend time on producing BOMs or Installation guides for this thing.
No parts require supports but there are some integrated supports and sacrificial layers which will require post print cleaning. Please message if unsure of this or orientation of specific printed parts.
All parts were printed in Amazon Basics Red PETG (PLA for non temp areas) as per the original assembly. Minimum 30% infill & 3 Perimeters.
Best wishes Boothy