Rollingstep Walker
door ekowi
Printbare bestanden (13)
-
stlfoot.stl
43 Ko · 1 457 downloads
-
stlrocker.stl
47 Ko · 1 452 downloads
-
stlbar.stl
43 Ko · 1 461 downloads
-
stlcrank_support.stl
102 Ko · 1 451 downloads
-
stlcrank.stl
68 Ko · 1 453 downloads
-
stltopframe.stl
32 Ko · 1 460 downloads
-
stlframe1.stl
107 Ko · 1 454 downloads
-
stlframe2.stl
117 Ko · 1 450 downloads
-
stlgear1.stl
93 Ko · 1 444 downloads
-
stlgear2.stl
284 Ko · 1 436 downloads
-
stlgear3.stl
277 Ko · 1 438 downloads
-
stlgear4.stl
188 Ko · 1 441 downloads
-
stlgear5.stl
237 Ko · 1 440 downloads
Beschrijving
We already know the Klann linkage, Theo Jansen / Strandbeest linkage, Chebyshev Lambda / Plantigrade, Ghassaei, Strider, Trotbot, and many more, which are all designs for walking mechanisms using single rotating crank and several bars connected with hinges. I tried yet another mechanism, using the common 4 bar linkage but with the foot link shaped such that the contact point is not constant. While the movement is advancing, different parts of the foot will touch the ground, like the heels and toes of human foot. This is similar to the rolling step technique used by marching bands, hence the name.
A vehicle could be propelled with 8 legs. I printed two copies of half a vehicle and mounted them on an acrylic plate. For the electric parts I used 2 DVD spindle motors, 2x 18650 lithium batteries, Arduino nano, HC-05 bluetooth, and robot controller board with 2 H-bridges.
Video:
https://youtu.be/hQ1YsS6fH44
The linkage bar lengths and foot shape are not optimized yet, this is just a first prototype. You are free to modify this and find a better design (and perhaps a proper research and publication).
Print list: fot half a vehicle
topframe x1 <-- all holes 3 mm diameter
frame1 x1 <-- all holes tapped for M3 screw
frame2 x1 <-- all holes tapped
foot x4 <-- 3 mm hole
bar x4, 2 mirrored, 3 mm holes
rocker x4 <-- 3 mm hole
crank x2 <-- 3 mm hole
gear1 x1 <-- 2 mm hole for motor shaft
gear2, gear3, gear4 x1 <-- 3 mm hole
gear5 x2
All screws used are M3 with lengths 40mm, 25mm, 20mm, 12mm, 10 mm. After printing, I need to clean the screw holes with drilling and form the thread with tapping, and several hours of whittling for the gears.
Only "crank.stl" needs support but I included "crank_support.stl" which already includes manual supports (which sticks somewhat to the part, i removed them with pliers).