Nerf technical(RC controlled)
por MrCrankyface
Ficheiros imprimíveis (12)
-
stlDualbarrel_-_jawlink-1.STL
23 Ko · 5 743 descargas
-
stlDualbarrel_-_elevationrod-1.STL
17 Ko · 5 763 descargas
-
stlbarrelx2.STL
15 Ko · 5 712 descargas
-
stlslidex2.STL
21 Ko · 5 790 descargas
-
stlBarrel2_B.STL
131 Ko · 5 691 descargas
-
stlDualBarrel2_B_inv.STL
130 Ko · 5 694 descargas
-
stl
Springholdx4.STL
92 Ko · 5 739 descargas
-
stlDualbarrel_-_base-1.STL
44 Ko · 5 690 descargas
-
stl
lockx2.STL
55 Ko · 5 740 descargas
-
stl
DualBarrel2_A.STL
244 Ko · 5 720 descargas
-
stl
dual_stand.STL
215 Ko · 5 749 descargas
-
stl
pushpinx2.STL
50 Ko · 5 622 descargas
Descrição
Roughly a week of development for this one and probably around 6 less successful prints, this is what came of it!
You hook it up to a receiver and use it as a standalone turret och put it on a RC vehicle. I hotglued it to the flatbed of my 3D printed RC truck V3, quite fun!
As usual I went wild with hardware ... You need these:
2x M3 rods x 40mm
2x m3 rods x 75mm
6x M4x10
19x m3x10
10x m3x16
3x standard size servos
2x 6700zz bearings
Couple of rubberbands or springs
2016-11-02 edit: Added the missing pushpin.
You can find videos about this project and others at my youtube channel: https://www.youtube.com/mrcrankyfaceprojects
Check me out at:
Youtube: http://www.youtube.com/c/MrCrankyfaceProjects
Instagram: https://www.instagram.com/mr.crankyface/
3d hubs: https://www.3dhubs.com/malm%C3%B6/hubs/mrcrankyface
Patreon: http://patreon.com/Mrcrankyface