Voron Electronics Case
por boohucky
Ficheiros imprimíveis (8)
-
stlRight_Door.stl
407 Ko · 1 840 descargas
-
stlLeft_Case.stl
1.5 Mo · 1 848 descargas
-
stlMiddle_Door.stl
391 Ko · 1 820 descargas
-
stlLeft_Door.stl
561 Ko · 1 829 descargas
-
stlRight_Case.stl
1.2 Mo · 1 837 descargas
-
stlFan_Grill.stl
321 Ko · 1 820 descargas
-
stlMiddle_Case.stl
1 Mo · 1 831 descargas
-
stepVoron_Electronics_Case.step
5.3 Mo · 1 757 descargas
Descrição
This is my electronics case for a standard size Voron 1.0 Corexy 3d printer. It is designed to fit the PSU, SSR, and Ramps 1.4 together in one package. All parts have been designed to be printed without support.
This case is intended to work with all of the electronic components in the Voron BOM. If your PSU does not have a 150mm x 50mm screw pattern, I've included the F360 file for modification. The Voron ramps fan guard will work with this case, but I've included a fan guard file that matches the vent pattern of the doors.
Wiring suggestions:
The case works best if wires are cut to length, but has enough space to fit full length stepper motor wires to allow for future modification/motor reuse. Inbound wires(stepper motors, Y endstop) enter through holes on the bottom of the case. The bed connector and fused power switch are snap fit.
Check out the Voron community and github:
https://www.reddit.com/r/voroncorexy/
https://github.com/mzbotreprap/VORON
Hardware for Assembly:
Case:
20 x M3 4mm(L) 4mm(OD) Brass Inserts (8 for case assembly, 12 for door threads)
8 x M3 10mm Socket Head Cap Screw
Case Mounting:
7 x M5 10mm Socket Button Head Screw
7 x M5 Drop in T-nut
Case Doors:
12 x M3 5mm Socket Head Cap Screw
Electronics Mounting:
6 x M4 8mm Socket Button Head Screw (PSU & SSR)
4 x M3 30mm Socket Head Cap Screw (Ramps fan)
2 x M3 20mm Socket Head Cap Screw (Ramps Board)
10 x Standard Zip Ties (~3.5mm width) (Cable Management)