Ceiling Hook
por renobot
Ficheiros imprimíveis (7)
-
stlhook_original.stl
1.6 Mo · 10 078 descargas
-
stlanchor.stl
71 Ko · 9 576 descargas
-
objanchor.obj
83 Ko · 8 607 descargas
-
obj
hook_original.obj
2.2 Mo · 8 603 descargas
-
obj
hook_stronger_sizing.obj
273 Ko · 8 619 descargas
-
obj
hook_stronger.obj
1.5 Mo · 8 691 descargas
-
stl
hook_stronger.stl
1.1 Mo · 9 266 descargas
Descrição
This is a two-piece ceiling hook assembly. Mount the anchor with a screw through the center hole, and then push on the hook, and twist 90 degrees to lock it into place. A small line on the anchor shows which way the hook will point.
This hook was designed for use with a drywall/plaster anchor, although you could also screw it directly to a joist. Or anything else, really. The hole and cavities are sized for a No.8-12 screw, but should fit larger screws as well.
Toleranced for a Replicator 2. See print instructions for details. The hook_stronger variant is thicker. Designed in Autodesk Fusion 360, with some manipulation in Autodesk meshmixer.