Clamping Knobs for T-Track

por johnv94

Ficheiros imprimíveis (2)

  • stl

    Dog_Clamp_Knob_-_Qtr_Inch_Sq_Nut.stl

    387 Ko · 644 descargas

    Descarregar
  • stl

    Dog_Clamp_Knob_Small_-_Qtr_Inch_Sq_Nut.stl

    404 Ko · 626 descargas

    Descarregar

Descrição

Recently, I made a drill press table with fence, router table with fence and bench clamps and needed some knobs to secure the fences and clamps using installed T-track.

So, I whipped up these two versions using Fusion 360 with the following design parameters:

  1. Had to work with 1/4" 75mm long bolts with square nuts that I already had laying around.

  2. Had to have a diameter no wider than than the drill press fence which was two 3/4" plywood boards sandwiched together at least for the smaller version (3/4" = 19mm).

I hope you find these useful.