Threaded Dust Filter

por Kezat

Ficheiros imprimíveis (4)

  • stl

    Threaded_Filter2_Center.stl

    984 Ko · 21 183 descargas

    Descarregar
  • stl

    Threaded_Filter2_Outer.stl

    3 Mo · 21 482 descargas

    Descarregar
  • stl

    Threaded_Filter_center_thicker.stl

    445 Ko · 19 467 descargas

    Descarregar
  • stl

    Craftbot_outer_filter.stl

    2.7 Mo · 19 205 descargas

    Descarregar

Descrição

Best of both worlds, no plastic tabs that become loose over time yet the convenience of inline attachment.
No extra hardware other then the sponge needed. Should work for 1.75 and 3mm filament.
Pinch filament between each half of a cut sponge and push all three in the small side and screw on the end cap.
Kitchen sponges seem to dry out, I have found that "Cellulose Facial Sponges" work well and are easy to find.

3-17-15
Uploaded a thicker walled center component.

4-10-15
Uploaded a version of outer portion that can thread on to the bottom filament guide of a Craftbot 3d printer.

Check out my other designs: http://www.thingiverse.com/Kezat/designs

Etiquetas

#dust remover #Filament filter #filter #makerbot