Atomstack X7 Pro Laser Module Clamp

por eddyogi

Ficheiros imprimíveis (4)

  • stl

    X7_Pro_Laser_Clamp_v9_X7_Pro_Laser_Clamp_v9_Left_X7_Pro_Laser_Clamp_v9.stl

    337 Ko · 284 descargas

    Descarregar
  • stl

    X7_Pro_Laser_Clamp_v9_X7_Pro_Laser_Clamp_v9_Right_X7_Pro_Laser_Clamp_v9.stl

    1.1 Mo · 283 descargas

    Descarregar
  • stl

    X7_Pro_Laser_Clamp_v9_X7_Pro_Laser_Clamp_v9_Bolt_X7_Pro_Laser_Clamp_v9.stl

    2.7 Mo · 289 descargas

    Descarregar
  • stl

    X7_Pro_Laser_Clamp_v9_X7_Pro_Laser_Clamp_v9_Bolt_on_bolt_X7_Pro_Laser_Clamp_v9.stl

    4 Mo · 285 descargas

    Descarregar

Descrição

NOTE: This is the updated design

I was unhappy with the stock bolt system to fix the laser module, mine would slide down a few millimetres as you tighten the bolt so I decided to design this. It is placed between the carriage plate and the laser module mounting bracket. The bolts at the back should just be long enough, they were on mine.

There are 2 printable bolts, one is designed so you can screw the stock bolt into the 3D printed one to reinforce it.