Potentiometer Knobs
por Old-Steve
Ficheiros imprimíveis (4)
-
stlknob15.stl
38 Ko · 121 descargas
-
stlknob-20.stl
37 Ko · 112 descargas
-
stlknob-30.stl
37 Ko · 111 descargas
-
stlknob-30-a.stl
77 Ko · 104 descargas
Descrição
My potentiometer knobs
I have 3 knobs.
15mm, 20mm, and 30mm diameters. All are 15mm’s tall.
There is a ¼” round hole (6mm’s X 12mm’s) for the potentiometer shaft with a pilot hole for a set screw. I used a 6-32 drill/tap combo bit to thread the hole.
There is a slot on top of each knob so you can slide in a piece of 1.75 filament as an indicator. I used white, yellow, and green for high contrast and visibility.
I printed these in PETG .2 layer 20% infill
- I added a fourth knob.
30mm diameter and I hollowed it out on the under side so it uses less plastic.