Carousel
von wjordan819
Druckbare Dateien (15)
-
stlspindle.stl
2 Ko · 2 138 Downloads
-
stlspindle_top.stl
49 Ko · 2 138 Downloads
-
stlcone.stl
206 Ko · 2 141 Downloads
-
stlbase.stl
264 Ko · 2 166 Downloads
-
stlhorse3.stl
370 Ko · 2 146 Downloads
-
stlcenter.stl
244 Ko · 2 148 Downloads
-
stlhorse1.stl
391 Ko · 2 162 Downloads
-
stlspacer.stl
54 Ko · 2 118 Downloads
-
stlhorse2.stl
384 Ko · 2 149 Downloads
-
stllocation_pegs.stl
14 Ko · 2 129 Downloads
-
stlcrank.stl
495 Ko · 2 134 Downloads
-
stlgears.stl
399 Ko · 2 123 Downloads
-
stlcrank_shaft.stl
2 Ko · 2 126 Downloads
-
stlwholething.stl
9 Mo · 2 229 Downloads
-
stlNew_Carousel_Top.stl
1.3 Mo · 583 Downloads
Beschreibung
UPDATE
It has been bought to my attention that the carousel top is incorrect. As I state in the description, I had to make some modifications to simplify the model. Unfortunately, I uploaded the original top piece and not the modified one. I apologise for any inconvenience this may have caused.
I was inspired to make this after the final episode of Call the Midwife which showed a wind up carousel.
After printing and assembling I found that some of the parts didn’t quite work the way I had intended. I altered these firstly to simplify the model and secondly to make assembly easier.
Most of the model was printed with an infill of 20%, the smaller parts I printed at 100%.
The model does need assembling and gluing, I used a good quality superglue. To help with the assembly I have included a PDF with assembly instructions.