Rusty (Battlebots)
by Scampi
Printable files (15)
-
stlChassis.STL
705 Ko · 134 downloads
-
stlBowl.STL
281 Ko · 136 downloads
-
stlTop_Shell.STL
26 Ko · 126 downloads
-
stlCage_Left.STL
52 Ko · 128 downloads
-
stlCage_Right.STL
52 Ko · 127 downloads
-
stlWheel.STL
304 Ko · 137 downloads
-
stlTread_Real.STL
80 Ko · 126 downloads
-
stlSide_Panel.STL
388 Ko · 125 downloads
-
stlBack_Panel.STL
94 Ko · 122 downloads
-
stlArms.STL
27 Ko · 126 downloads
-
stlArm_Base.STL
42 Ko · 127 downloads
-
stlArm_Plate.STL
74 Ko · 128 downloads
-
stlChisel_Mount.STL
8 Ko · 127 downloads
-
stlChisel.STL
168 Ko · 126 downloads
-
stlChisel_Ring.STL
19 Ko · 127 downloads
Description
It's Rusty! From Battlebots! Yes! I made this by looking at a ton of different photos of Rusty from as many angles as possible, and this helped me get most of the proportions and details right, I think. Ideally I'd spend an afternoon with Rusty and a tape measure to get it perfect.
I don't have time to really sort or organize this properly, so here's everything; the part files, the step files, and the stl files. This is more of a project than a ready-to-print model.
- The holes for the switch, nails, and LEDs might not match what you have on hand, so you may need to modify them.
- You will also probably need to do a bit of sanding on a lot of the parts to get them to fit right.
- For paint, I used Testors metallic silver and flat rust.
- The treads will need to be printed from a flexible filament like TPU.
- The hole on the back of Rusty is for a countersunk M3 screw, this was to make the back panel removable to unlock the top cover to get inside, but removing the bowl instead proved easier. If you want to glue the bowl on, keep the back panel removable, otherwise you can glue it on instead of using a screw.