Modular floating wind platform

por AndreECN

Ficheiros imprimíveis (10)

  • stl

    modular_float-buoy.stl

    1.3 Mo · 151 descargas

    Descarregar
  • stl

    modular_float-buoy_heavy.stl

    547 Ko · 147 descargas

    Descarregar
  • stl

    modular_float-buoy_hexa.stl

    1.9 Mo · 144 descargas

    Descarregar
  • stl

    modular_float-fairlead001.stl

    78 Ko · 141 descargas

    Descarregar
  • stl

    modular_float-mooring_head001.stl

    91 Ko · 140 descargas

    Descarregar
  • stl

    pin_11mm.stl

    21 Ko · 143 descargas

    Descarregar
  • stl

    pin_51mm.stl

    135 Ko · 143 descargas

    Descarregar
  • stl

    pin_101mm.stl

    135 Ko · 142 descargas

    Descarregar
  • stl

    half_cone_10mm.stl

    41 Ko · 141 descargas

    Descarregar
  • stl

    pin_2mm.stl

    21 Ko · 142 descargas

    Descarregar

Descrição

This is a kit to build your own floating wind platform ! They are designed to serve as platforms for the NREL 5MW model from https://www.thingiverse.com/thing:7057563

Here are guidelines to assemble different types of platforms :

Semi submersible platform

  • print four copies of "modular_float_buoy"
  • print three copies of "pin 51mm"
  • connect one buoy to the three others, at a 120° angle
  • use the "pin 11mm" to connect the wind turbine

Tension leg platform

  • print one copy of "modular_float_buoy"
  • print three copies of "pin 101mm" , three copies of "modular_float_mooring_head" and three copies of "modular_float_fairlead"
  • print the sea floor from https://www.thingiverse.com/thing:7165848
  • attach a string from each fairlead to each mooring head
  • set the three mooring head on the three 101mm pins, at a 120° angle with one another
  • attach the fairlead to the sea-bed
  • fill water in your tank so that 4/5 of the buoy is submerged
  • use the "pin 11mm" to connect the wind turbine

SPAR type platform

  • print two copies of "modular_float_buoy" , connect them on top of one another with the "pin 11mm"
  • print one copy of "modular_float_buoy_heavy" , add some ballast to it so it weights approx 200g, you can seal the ballast hole with "half_cone_10mm". Use the the "pin_2mm" to connect it to the upper buoy
  • use the "pin 11mm" to connect to the wind turbine tower

Invent other platforms

You can also invent any design of your liking, using ballast, legs and mooring lines. The piece "modular_float_hexa_buoy" can be used to extend your design capabilities by allowing 60° angles.

Etiquetas

#floating wind turbine #wind turbine