HyperCube 3D Printer M4 Variant
von zargony
Druckbare Dateien (14)
-
stlBed_Support_v1.1_M4.stl
71 Ko · 1 480 Downloads
-
stlSpool_Axle_Clamp_M4.stl
256 Ko · 1 478 Downloads
-
stlXY_Idler_M4.stl
263 Ko · 1 481 Downloads
-
stlXY_Motor_left_M4.stl
259 Ko · 1 512 Downloads
-
stlXY_Motor_right_M4.stl
257 Ko · 1 522 Downloads
-
stlY_Shaft_Clamp_Left_Motor_M4.stl
194 Ko · 1 484 Downloads
-
stlY_Shaft_Clamp_M4.stl
193 Ko · 1 472 Downloads
-
stlZ_Carriage_M4.stl
386 Ko · 1 476 Downloads
-
stlZ_EndStop_Adjust_v1.1_M4.stl
63 Ko · 1 372 Downloads
-
stlZ_leadscrew_support_v1.1_M4.stl
128 Ko · 1 482 Downloads
-
stlZ_Motor_v1.1_M4.stl
258 Ko · 1 486 Downloads
-
stlZ_nut_mount_v1.1_M4.stl
332 Ko · 1 481 Downloads
-
stlZ_Shaft_Clamp_v1.1_M4.stl
240 Ko · 1 495 Downloads
-
stlDual_bushing_holder_M4.stl
144 Ko · 1 390 Downloads
Beschreibung
This is a derivation of Tech2C's excellent HyperCube 3D printer. Most noticable differences to original parts are M4 holes for mounting plastic parts to I-type extrusions.
See links below for other things related to my customized HyperCube 3D printer build.
Only modified parts are contained here. For the full list of parts, refer to the original build instructions.
Modifications
M4 holes
All parts that mount to 20x20 extrusions are modified to use M4 screws instead of the default M5. Therefore it's possible to use Type I extrusions which have a 5mm slot and can take M4 nuts max.
Round holes
The rectangular slots that allow putting nuts through a part are replaced with round (elongated) holes. There's no need to have large slots if you use t-slot sliding nuts that can be inserted to the slot anywhere.
Slot guide for Z endstop adjust
The Z endstop adjust now has a small slot guide to prevent twisting.
See also
Other things related to my customized HyperCube 3D printer build:
Changelog
- 2017-05-22: Fixed z endstop slot guide orientation
- 2017-04-30: Added Dual_bushing_holder and simple 2020 corner brackets