HyperCube 3D Printer M4 Variant
por zargony
Ficheiros imprimíveis (14)
-
stlBed_Support_v1.1_M4.stl
71 Ko · 1 481 descargas
-
stlSpool_Axle_Clamp_M4.stl
256 Ko · 1 479 descargas
-
stlXY_Idler_M4.stl
263 Ko · 1 482 descargas
-
stlXY_Motor_left_M4.stl
259 Ko · 1 513 descargas
-
stlXY_Motor_right_M4.stl
257 Ko · 1 523 descargas
-
stlY_Shaft_Clamp_Left_Motor_M4.stl
194 Ko · 1 485 descargas
-
stlY_Shaft_Clamp_M4.stl
193 Ko · 1 473 descargas
-
stlZ_Carriage_M4.stl
386 Ko · 1 477 descargas
-
stlZ_EndStop_Adjust_v1.1_M4.stl
63 Ko · 1 373 descargas
-
stlZ_leadscrew_support_v1.1_M4.stl
128 Ko · 1 483 descargas
-
stlZ_Motor_v1.1_M4.stl
258 Ko · 1 487 descargas
-
stlZ_nut_mount_v1.1_M4.stl
332 Ko · 1 483 descargas
-
stlZ_Shaft_Clamp_v1.1_M4.stl
240 Ko · 1 496 descargas
-
stlDual_bushing_holder_M4.stl
144 Ko · 1 391 descargas
Descrição
This is a derivation of Tech2C's excellent HyperCube 3D printer. Most noticable differences to original parts are M4 holes for mounting plastic parts to I-type extrusions.
See links below for other things related to my customized HyperCube 3D printer build.
Only modified parts are contained here. For the full list of parts, refer to the original build instructions.
Modifications
M4 holes
All parts that mount to 20x20 extrusions are modified to use M4 screws instead of the default M5. Therefore it's possible to use Type I extrusions which have a 5mm slot and can take M4 nuts max.
Round holes
The rectangular slots that allow putting nuts through a part are replaced with round (elongated) holes. There's no need to have large slots if you use t-slot sliding nuts that can be inserted to the slot anywhere.
Slot guide for Z endstop adjust
The Z endstop adjust now has a small slot guide to prevent twisting.
See also
Other things related to my customized HyperCube 3D printer build:
Changelog
- 2017-05-22: Fixed z endstop slot guide orientation
- 2017-04-30: Added Dual_bushing_holder and simple 2020 corner brackets