microscope adjustable stand
von 8orge
Druckbare Dateien (17)
-
stlTurning-knob-ornament1.stl
24 Ko · 2 415 Downloads
-
stlBase_-_Ornament.stl
8 Ko · 2 407 Downloads
-
stlTurning-knob-ornament4.stl
53 Ko · 2 376 Downloads
-
stlRubber-adjuster-plate.stl
58 Ko · 2 412 Downloads
-
stlScope-arm-left-ornament.stl
2 Ko · 2 401 Downloads
-
stltop-ballbearing-mount-v2.stl
59 Ko · 2 420 Downloads
-
stlTurning-knob-ornament3.stl
28 Ko · 2 399 Downloads
-
stlScope-arm-right-ornament.stl
2 Ko · 2 381 Downloads
-
stlTurning-knob-ornament6.stl
18 Ko · 2 374 Downloads
-
stlTurning-knob-ornament2.stl
135 Ko · 2 381 Downloads
-
stlSpindel-rod.stl
1.3 Mo · 2 466 Downloads
-
stlBase_Rubber_Foot.stl
242 Ko · 2 386 Downloads
-
stlTurning-knob.stl
858 Ko · 2 428 Downloads
-
stlScope-arm.stl
1.9 Mo · 2 488 Downloads
-
stlBase.stl
1.6 Mo · 2 451 Downloads
-
stlSpindel-housing-v2.stl
371 Ko · 2 461 Downloads
-
stlTurning-knob-ornament5.stl
1 Ko · 2 421 Downloads
Beschreibung
This is a hight adjustable stand for a usb microscope .
The total hight with the optional rubber foot is 230mm .
If you found this design very helpful or otherwise wish to support me ,you can buy me a cup of coffee ( helps keeping the brain active so i can create new stuff ) ;-) ,then please
consider using this link :
What you need to assemble this is :
1 pcs m5 x 12mm hex cap head bolt
1 pcs m5 nut
2 pcs Ballbearing 8x16x5mm
The arm that holds the microscope has to be inserted first
in the middle of the tower ,it has to go in with one side first and
then the other can be pushed in ,insert then the lower ballbearing ,
then insert the rubber spacer plate in the back and then
insert the spindel rod ,remember the ballbearing in the top
piece before before pushing it in the tower :-) .
The rubber foot and the rubber spacer plate were made
from NinjaFlex , the rest is normal Pla .