Split flap display module

por Ajaxjones

Ficheiros imprimíveis (13)

  • stl

    drumidler_V2.stl

    90 Ko · 867 descargas

    Descarregar
  • stl

    split_flap_holder.stl

    70 Ko · 866 descargas

    Descarregar
  • stl

    Split_Flap_Drum_V2.stl

    169 Ko · 861 descargas

    Descarregar
  • stl

    Motormount_V2.stl

    295 Ko · 856 descargas

    Descarregar
  • stl

    drumgear_V2.stl

    238 Ko · 863 descargas

    Descarregar
  • stl

    split_hub_shaft.stl

    15 Ko · 863 descargas

    Descarregar
  • stl

    flap.stl

    57 Ko · 838 descargas

    Descarregar
  • stl

    drummount_V2.stl

    96 Ko · 861 descargas

    Descarregar
  • stl

    spacer.stl

    56 Ko · 833 descargas

    Descarregar
  • stl

    drum2_V2.stl

    269 Ko · 861 descargas

    Descarregar
  • stl

    split_flap_-_lifting_eye.stl

    219 Ko · 854 descargas

    Descarregar
  • stl

    drivegear_V2.stl

    357 Ko · 858 descargas

    Descarregar
  • stl

    split_flap_tank.stl

    2.4 Mo · 857 descargas

    Descarregar

Descrição

A split flap display using a Wemos D1 R1 and a ULN2003 driver board with the 28byj-48 stepper motors. The original design was from Jonas Bonjeanand I've reworked the files to create this one. The main changes were as follows. Additions to the motor mount to be able to fit the electronics on board , changed the drum internals to fit the shaft along with the placement of a 2mm bolt which secures the flaps onto the drum without having to glue the end cap in place. I also mirrored and changed the drum end support to reflect the main drum and added a faux fuel tank to cover the NC end stop.Full build details and instructional along with the code are on Instructables. See the remix link for the original files.

https://www.instructables.com/id/Split-Flap-Display-Antique-Remix/

https://youtu.be/QGbsA8GWvSE

https://youtu.be/sWD3K5h7gfM

Etiquetas

#flapper #split flap #Split Flap Display #split-flap #splitflap